39303045 Connector: Detailed Specs, Test Data & PCB Footprint

5 February 2026 112

Compact 4-pin power headers remain a go-to for low-voltage board interconnects because they balance current capacity and PCB real estate. This guide provides verified specs, test data, and layout guidance to accelerate your design-to-production cycles.

Background & Connector Overview

Part Context: The family is intended as a small-power board-to-wire/board-to-board header used where space and reliable power distribution are required. Its 4-position single-row format suits industrial control modules, consumer power supplies, and compact daughtercard headers.

Key Dimensions: Typical configuration is 4 positions, single row, 4.2 mm pitch, right-angle through-hole mounting. Assign heaviest load to outer pins and keep return/ground on adjacent pins for thermal and current sharing.

39303045 Connector Layout and Dimensions

Detailed Connector Specifications

Parameter Value / Specification
Pitch 4.2 mm
Positions 4
Mounting Type Through-hole, right-angle
Rated Current 5–10 A / contact (typical)
Rated Voltage ≤250 VAC/DC
Housing Material Glass-filled nylon (UL 94V-0)

Validated Performance & Test Outcomes

Insertion Force (N/pin)
Spec: ≤10N Measured: 6–9N
Contact Resistance ΔR (mΩ)
Spec: Measured: ≤5mΩ
Retention Force (N total)
Spec: ≥20N Measured: 22–30N

PCB Footprint & Layout Guide

Use plated through-hole (PTH) drill tolerance of ±0.05 mm and solder mask clearance to avoid bridging. These values ensure reliable fillets and mechanical strength under high vibration.

Critical Note

Maintain mating clearance on the connector face; avoid placing passive components within 3mm of the saddle area to ensure proper mating tool access.

Feature Recommendation
Drill Size Ø1.05 mm
Pad Size Ø2.5 mm
Annular Ring ≥0.25 mm
Solder Mask 0.15 mm clearance

Pre-production Checklist

  • ✓ Verify footprint geometry in ECAD against mechanical drawing and 3D STEP export.
  • ✓ Confirm drill and pad sizes with fabricator; order sample parts for fit check.
  • ✓ Run thermal derating calculation and confirm trace widths for continuous current.
  • ✓ Build test coupon with mating connector to validate insertion force and clearance.

Frequently Asked Questions

What drill and pad sizes should I use for the power header? +
Use a PTH drill around Ø1.05 mm with a pad diameter near Ø2.5 mm and at least 0.25 mm annular ring. These sizes offer robust solder fillets and accommodate typical PTH tolerances for reliable performance.
How should I size PCB traces for continuous current? +
Calculate trace width using IPC thermal tables. For 5–10 A per pin, consider multiple parallel traces or use outer pins in parallel and increase copper weight (e.g., 2oz copper) to share the thermal load effectively.
Which assembly process is preferred for this connector type? +
Wave soldering is the most efficient for high-volume production. For mixed-technology boards, selective soldering or hand soldering is acceptable, provided preheating is used to minimize thermal shock and ensure full solder wetting.

Summary of Best Practices

The 39303045 header provides a compact 4-position solution for low-voltage power. To ensure field reliability, designers must validate footprint geometry, derate continuous currents, and incorporate mechanical anchors for high-vibration environments. Pre-production checks remain the single most effective way to prevent costly assembly regressions.